I'm wondering if this issue can explain my problems in booting a xen dom0 domain on a 530 drive (gigabyte z87x-ud5h mainboard).
I can boot the linux installation (without xen) and everything works fine except failure to detect drive at reboot.
Booting xen hypervisor works but the ssd drive is not detected when the dom0 linux kernel boots. I have verified that the sata controller is using the ahci kernel module. The only problem seems to be that the drive can't be detected. A bit interesting since it was detected a couple of seconds earlier when the hypervisor was able to read both kernel and initial ramdisk from the drive.
Could it be that the handover of the disk from hypervisor boot to linux dom0 kernel follows a similar process as a reboot, hence making it impossible to boot (even cold boot)? I can wait for a little while to have this fixed but not for long since the computer is bricked until the issue is fixed.
Is it likely that I have run into the same issue or is this something else that won't be fixed in the december update? Trying to decide if I should send the drive back or not.
Best Regards,
/Martin